Posts Tagged ‘ham radio kit’

SPECIAL DEAL ON 6V6 MC 80 M PASTIME PROJECTS TRANSMITTER KIT

August 9, 2016

Today we are offering a special on our pastime projects 6V6 MC 80 Kit. This kit includes a wound and tested
Output plug in coil tested on 80 meters in our shop. In addition, we will include a new 3.5795 crystal element assembled in a FT-243 or similar style vintage type crystal holder. These are assembled and tested here, both
on a communications monitor and in a completed 6V6MC 80 Kit. These crystals are performing well for us in the
lab here at Pastime Projects, especially using our QRP mode power supply at 200 volts. The crystals have been
tested at 350 VDC with good results, but we are not ready to warranty the crystals at this time. For a limited
time we will also offer free shipping within the US. Delivery may run a little longer depending on demand,
but we are starting to build stock in advance of orders. 73 best wishes Glenn Brown for http://www.pastimeprojects.com and pastimeprojects(at)yahoo(dot)com.

Pastime Projects High Voltage Power Supplies

September 3, 2015

Pastime Projects (www.pastimeprojects.com) manufactures amateur radio kits. Two of our most favorite are the “Remember When” slat board 6V6 kit which was featured in the 1948 (and elsewhere) ARRL Amateur Radio Handbook. This simple transmitter used a 6V6 (or 6L6) vacuum tube on a chassis made of orange crate wood. It was designed for the amateur radio operator to send CW (code) on 80 or 40 meters.
Our more recent kit uses a metal chassis and an improved oscillator kit introduced in the 1960’s Handbooks. It was more stable, easier on crystals, and oscillated on 80, 40 and other bands by switching plug-in coils. Ours uses a 50 ohm link coupled output which matches today’s antennas, antenna tuners, low pass filters, and dummy loads.
These circuits, as first published, were often accompanied by a power supply design which used a 5 volt rectifier vacuum tube. We chose to use modern solid state silicon rectifiers instead. This eliminated the need for a 5 volt winding on the transformer, and the added heat, light, current demand, vacuum tube, tube socket and so
on associated with the rectifier tube.
The result is a simpler less costly power supply for you to build and enjoy. Best regards, Glenn Brown W8JZI for pastimeprojects.com